Which Show command shows you the "clock rate"?

I use the Show controller to see DTE or DCE but I can't find the Show command that tells you if the clock rate has been set to the serial port. Thx.

I'm working on a lab and Router 1 and Router two are not pinging each others.

Serial1/1 172.22.2.2 YES unset up down

I checked the clock rate, RIP2 is on, not sure where else to look..

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

cisco_kidd

SurferdudeHB wrote: »

I use the Show controller to see DTE or DCE but I can't find the Show command that tells you if the clock rate has been set to the serial port. Thx.

I'm working on a lab and Router 1 and Router two are not pinging each others.

Serial1/1 172.22.2.2 YES unset up down

I checked the clock rate, RIP2 is on, not sure where else to look..

show int <interface>

Todd Burrell

I'm pretty sure it will also show up with the SHOW RUNNING-CONFIG command, or SHOW RUN for short.

Everlife

The show controllers command will display the clock rate. You need to make sure you run the command from the router that contains the interface you set the clock rate on.