PuTTY Default Configuration

Hello Fellow CCNP'rs

Today I've been messing around with the default putty configurations - and I can't for the life of me figure out this one particular setting...

Catagory>Window I have increased the starting size from 24 rows and 80 columns to 48/85 respectively to fit all the Cisco cmds in a nice tight fit, however when I go and run a log command... for example Show Running-config PuTTY only displays 24 lines at a time and I have to keep parsing through the spacebar. Please tell me there is a way to change this default.

PS
Normally I use ZOC and have no issues with this, but would also like to be comfortable with PuTTY, as I can't seem to get ZOC to work with GNS3 happily.

Thanks in advance,
CiscoCerts

Find more posts tagged with

Comments

networker050184

Just do a term length 0 from the cli and it will spit it all out. As far as I know its not your PuTTY config that handles this.

CiscoCerts

networker050184 wrote: »

Just do a term length 0 from the cli and it will spit it all out. As far as I know its not your PuTTY config that handles this.

AWESOME!! Thank you very much good Sir. I will be adding this to my standard 'lab commands'.

networker050184

CiscoCerts wrote: »

AWESOME!! Thank you very much good Sir. I will be adding this to my standard 'lab commands'.

Also a good first command in scripts to gather output!

CiscoCerts

Show terminal is also helpful in matching up a terminal emulator with what is already set on the router/switch

Router#show term
Line 514, Location: "", Type: "vt220"
Length: 73 lines, Width: 114 columns
Baud rate (TX/RX) is 9600/9600
Status: PSI Enabled, Ready, Active, No Exit Banner, Automore On
  Notify Process
Capabilities: none
Modem state: Ready
Group codes:    0
Special Chars: Escape  Hold  Stop  Start  Disconnect  Activation
                ^^x    none   -     -       none
Timeouts:      Idle EXEC    Idle Session   Modem Answer  Session   Dispatch
               00:10:00       00:15:00                       none     not set
                            Idle Session Disconnect Warning
                              never
                            Login-sequence User Response
                             00:00:30
                            Autoselect Initial Wait
                              not set
Modem type is unknown.
Session limit is not set.
Time since activation: 00:07:47
Editing is enabled.
History is enabled, history size is 20.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are ssh.
Allowed output transports are lat pad telnet rlogin lapb-ta mop v120 ssh.
Preferred transport is none.
No output characters are padded
No special data dispatching characters