2511RJ Log Posted -- Does it have 16Flash?

ciscoman2012

This is tripping me up.

Here is the log of my 2511RJ. Do I just need to unpartition both of these and then it will turn into 16 or what?




2511AS#sh ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-I-L), Version 12.1(24), RELEASE SOFTWARE (fc2)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Wed 12-May-04 03:40 by cmong
Image text-base: 0x03041FF0, data-base: 0x00001000

ROM: System Bootstrap, Version 11.0(10c)XB1, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)
BOOTLDR: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c)XB1, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1)

2511AS uptime is 5 minutes
System returned to ROM by power-on
System image file is "flash:c2500-i-l.121-24.bin"

cisco AS2511-RJ (68030) processor (revision E) with 14336K/2048K bytes of memory.
Processor board ID 15662278, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
16 terminal line(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash partition 1 (Read ONLY)
8192K bytes of processor board System flash partition 2 (Read/Write)

Configuration register is 0x2102

spicy ahi

Try a "show flash" and see if your mem is partitioned. If it is, then yes, you have 16MB of flash. Just have to run a "no flash partition" to delete the partitions.

ciscoman2012

spicy ahi wrote: »

Try a "show flash" and see if your mem is partitioned. If it is, then yes, you have 16MB of flash. Just have to run a "no flash partition" to delete the partitions.

Thanks for the insight. Wish I had a way to turn on the power to my rack remotely and I could tell you right now lol