Eigrp Metric Weights
Roguetadhg
Member Posts: 2,489 ■■■■■■■■□□
in CCNP
Why is the "Type of service" a variable, when it must be 0?
Cisco IOS Release 12.0 Network Protocols Command Reference, Part 1 - EIGRP Commands - Cisco Systems
R2(config-router)# metric weights [COLOR=#ff0000][B]0[/B][/COLOR] 1 0 1 1 0The first variable (0) has been noted to always be Zero.
Cisco IOS Release 12.0 Network Protocols Command Reference, Part 1 - EIGRP Commands - Cisco Systems
In order to succeed, your desire for success should be greater than your fear of failure.
TE Threads: How to study for the CCENT/CCNA, Introduction to Cisco Exams
TE Threads: How to study for the CCENT/CCNA, Introduction to Cisco Exams
Comments
-
martell1000
Member Posts: 389
because eigrp (and ospf) dont support TOS the value has to be 0 for the router to process it.And then, I started a blog ... -
SteveO86
Member Posts: 1,423
Found this IPExpert
EIGRP Metric & K-Values
It states it was never fully implemented into EIGRP so it has to be set to Zero.
This article starts talking about it, but since it was never implemented. We should probably just set it zero, remember what it is and why, then never look at it again
My Networking blog
Latest blog post: Let's review EIGRP Named Mode
Currently Studying: CCNP: Wireless - IUWMS -
Roguetadhg
Member Posts: 2,489 ■■■■■■■■□□
It seemed like something that slipped through the cracks then.In order to succeed, your desire for success should be greater than your fear of failure.
TE Threads: How to study for the CCENT/CCNA, Introduction to Cisco Exams