basic settings and implementation of EIGRP - 1

i have started to post again. I will go deeper and deeper (as much as i know). I have tried to show everything in a clear way and support them by pictures and comments

IP Routing from scratch. EIGRP implementation-1 (includes basic settings and tweaks) « studentCodes

Find more posts tagged with

SAVE $250 on Your CISCO Boot Camp — Use Code "EXAM26"

Exclusively for TechExams members for Infosec Boot Camps starting before April 30, 2026

View CISCO Boot Camps

Comments

martell1000

nice. i like the how it looks from the outside section. gives it a "real world" touch!

joshmadakor

I haven't seen anyone do it like that before, very cool.

NetworkVeteran

GOZCU wrote: »

i have started to post again. I will go deeper and deeper (as much as i know). I have tried to show everything in a clear way and support them by pictures and comments

IP Routing from scratch. EIGRP implementation-1 (includes basic settings and tweaks) « studentCodes

router1(config)#router eigrp 10 // classfull network address to advertise
router1(config-router)#network 10.0.0.0

Nice article. I noted one technical inaccuracy. Those statements, in your topology, will not cause EIGRP to advertise 10.0.0.0 or any other classful network address. You can turn on eigrp debugging to verify that. What they will do, is cause EIGRP to run on any interfaces with IPv4 addresses that look like 10.x.x.x.

You probably knew that, but some readers may not, and Cisco exams tend to be nitpicky.

GOZCU

You are definitely right, to be honest i wrote like that to tell what a routing protocol does generally. To give a main idea..... but i will change it right now. There are dozen of books around there and some of them uses the same information to teach. thanks for the head up

NetworkVeteran wrote: »

Nice article. I noted one technical inaccuracy. Those statements, in your topology, will not cause EIGRP to advertise 10.0.0.0 or any other classful network address. You can turn on eigrp debugging to verify that. What they will do, is cause EIGRP to run on any interfaces with IPv4 addresses that look like 10.x.x.x.

You probably knew that, but some readers may not, and Cisco exams tend to be nitpicky.

GOZCU

joshmadakor wrote: »

I haven't seen anyone do it like that before, very cool.

thank you, i will try to write as much as i can from today