frame relay problem in GNS3
I am having difficulty setting up frame relay in GNS3. The following output is from R1
R1#SHOW FRAME MAP
Serial0/0.145 (up): ip 172.14.15.4 dlci 104(0x68,0x1880), static,
broadcast,
CISCO, status defined, active
Serial0/0.145 (up): ip 172.14.15.5 dlci 105(0x69,0x1890), static,
broadcast,
CISCO, status deleted
Serial0/0.12 (up): point-to-point dlci, dlci 102(0x66,0x1860), broadcast
status defined, active
Serial0/0.13 (down): point-to-point dlci, dlci 103(0x67,0x1870), broadcast
status deleted
Anyone know why the PVC status would be deleted? i have configured the ports and dlcis on the frame relay switch
I have attached screenshots of the topology and the FR switch config.
R1#SHOW FRAME MAP
Serial0/0.145 (up): ip 172.14.15.4 dlci 104(0x68,0x1880), static,
broadcast,
CISCO, status defined, active
Serial0/0.145 (up): ip 172.14.15.5 dlci 105(0x69,0x1890), static,
broadcast,
CISCO, status deleted
Serial0/0.12 (up): point-to-point dlci, dlci 102(0x66,0x1860), broadcast
status defined, active
Serial0/0.13 (down): point-to-point dlci, dlci 103(0x67,0x1870), broadcast
status deleted
Anyone know why the PVC status would be deleted? i have configured the ports and dlcis on the frame relay switch
I have attached screenshots of the topology and the FR switch config.
I'm an Xpert at nothing apart from remembering useless information that nobody else cares about.
