Setting Up Two Phones with CME

boostinbadgerboostinbadger Member Posts: 256
in CCNA & CCENT
Does anyone know of a good guide somewhere on how to configure a small CME setup with FlowRoute? I have a maxed 1760 that I want to use as my CME router.
· Share on FacebookShare on Twitter

Comments

  • azaghulazaghul Member Posts: 569 ■■■■□□□□□□
    I'm guessing you are trying to set up a SIP trunk to the 1760, instead of using an ATA? They should all be much the same regardless of ISP.

    I did that as proof-of-concept, before installing an ATA, the 1760 was a bit on the loud side for residential use. (877W ADSL gateway pointing to a 1760 w/CME)
    · Share on FacebookShare on Twitter
  • boostinbadgerboostinbadger Member Posts: 256
    You got it azaghul. You helped me last year when I was planning on starting this project but then life happened :) This is the current topo:

    E4200
    |
    2940--1760
    |
    3550


    Native vlan is 59. Voice will be 159. I am going to configured fa 0/0 with two sub interfaces.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.