Router 2020xm does not load start-up config

joluis9

I have this router that every time I reload it won't load the start-up config, it just resets itself to factory settings but, when I do show start-up config I see my config saved. Is there a command to tell it to load it?

Thanks

docrice

What's the config-register value set at?

phoeneous

joluis9 wrote: »

I have this router that every time I reload it won't load the start-up config, it just resets itself to factory settings but, when I do show start-up config I see my config saved. Is there a command to tell it to load it?

Thanks

Post the config.

From the sound of it, you need to specify the boot system command.

joluis9

It is 0x2142

joluis9

what config? the start-up?

docrice

You need to set the config-register to 0x2102. Otherwise it will bypass the start-up config.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

joluis9

Thanks man, that was it. It might have happened when I googled how to restore to default setting, it told me to change the config-register.

Back to labbing