Need help connecting Switch to Router

Trying to set up a home lab for basic command line practice. Below is my topology and I've emulated a cisco switch into GNS3 as per https://learningnetwork.cisco.com/docs/DOC-13824

Able to ping from R1 to R2

Unable to ping from S1 to R1

Configuration below:

R1 int s0/0
ip address 192.168.1.1 255.255.255.252
no shutdown

R2 int s0/0
ip address 192.168.1.1 255.255.255.252
no shutdown

R1 int f1/0
ip address 172.30.2.1 255.255.255.0
no shutdown

S1 int Vlan 1
ip address 172.30.2.180 255.255.255.0
ip default-gateway 172.30.2.1
no shutdown

Am i doing something wrong here ? Do I need to set up interface f0/0 on Switch 1 ? Does the S1 subnet need to be same as R1 ?

Do i need to do the following ?
int f0/0
switchport mode access
switchport access vlan 1

untitled.JPG

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

r_durant

Are both interfaces up/up?
What's the duplex/speed settings on both devices?

kurosaki00

did you:
interface fastethernet 0/0
if- switchport access vlan 1 ?

also no shutdown on vlan 1 and fa0/0?

chiggah

kurosaki00 wrote: »

did you:
interface fastethernet 0/0
if- switchport access vlan 1 ?

also no shutdown on vlan 1 and fa0/0?

Nah yeah i just figured that out about 20 minutes before your post

Need to assign S1 f0/0 to Vlan 1

Thanks though - will try when I get home