Memory issue 2611XM?
petedude
Member Posts: 1,510
in CCNA & CCENT
IOS (tm) C2600 Software (C2600-I-M), Version 12.3(13), RELEASE SOFTWARE (fc2)
System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)
Boot ROM says there's 262144 Kbytes of memory.
show version reports:
cisco 2611XM (MPC860P) processor (revision 0x100) with 126976K/4096K bytes of memory.
Why does IOS not report the full 256Kb of RAM?
System Bootstrap, Version 12.2(8r) [cmong 8r], RELEASE SOFTWARE (fc1)
Boot ROM says there's 262144 Kbytes of memory.
show version reports:
cisco 2611XM (MPC860P) processor (revision 0x100) with 126976K/4096K bytes of memory.
Why does IOS not report the full 256Kb of RAM?
Even if you're on the right track, you'll get run over if you just sit there.
--Will Rogers
--Will Rogers
Comments
-
spd3432
Member Posts: 224
I believe it takes a specific ROM in order for all 256mb RAM to be recognized in the 2600xm series routers.
Not meaning to be demeaning but did you do a memory upgrade yourself? Perhaps with 2 x 128mb sticks? Did you verify both are good (booted with one, then booted with the other)? Sometimes you get bad memory and the device can't pick it up correctly.----CCNP goal----
Route [ ] Studying
Switch [ ] Next
Tshoot [ ] Eventually