GNS3 and SDM question
altdrugz
Member Posts: 69 ■■□□□□□□□□
in CCNA & CCENT
Hi,
straight forward...since my IOS image is an "advanced enterprise" edition why I do not have access to several tabs in SDM probing me that the edition of my IOS does not support them. Tabs like: Firewall and ACL/IPS/QoS and from Monitor Firewall Status/ IPS and 802.1x .
straight forward...since my IOS image is an "advanced enterprise" edition why I do not have access to several tabs in SDM probing me that the edition of my IOS does not support them. Tabs like: Firewall and ACL/IPS/QoS and from Monitor Firewall Status/ IPS and 802.1x .
Comments
-
spd3432
Member Posts: 224
Because not all IOS's are created equal. You'd need to go to Cisco feature navigator to see what is available in your IOS. Cisco Feature Navigator - Cisco Systems----CCNP goal----
Route [ ] Studying
Switch [ ] Next
Tshoot [ ] Eventually -
altdrugz
Member Posts: 69 ■■□□□□□□□□
Hmmm well... According to that I should had all the tabs enabled actually... :S 12.4(11)T1 version for a 7200 model.
-
spd3432
Member Posts: 224
Things like IPS might require additional signature files to be installed -- think I ran into this and ended up running a 1721 since it had a base set of definitions in the IOS. I've not run SDM inside GNS3, only used it with real hardware.----CCNP goal----
Route [ ] Studying
Switch [ ] Next
Tshoot [ ] Eventually