[Packet Tracer] Non-static routing throguh Linksys WRT300N?
hixantum
Member Posts: 7 ■□□□□□□□□□
in CCNA & CCENT
I have my network topology set similarly to Todd Lammle's CCNA book; i.e consisting of two 2811 routers, 2 1841 routers, and a Linksys wireless WRT300N connected to an 1841 router.
When I configured static routes, I was able to communicate with the WRT300N flawlessly, from all/any remote router's network nodes. After setting RIP/RIP2 & even EIGRP (currently set), I can't communicate with the wireless wrt300N. The command, redistribute static on R3, which the wrt300N is connected to directly, didn't do anything.
It seems the router only has a default route set up on it as well.
It's routing table
Type
Network
Port
Next Hop IP
Metric
C
192.168.31.0 /24
Internet
---
0/0
C
192.168.32.0 /24
Vlan 1
---
0/0
S
0.0.0.0 /0
---
192.168.31.1
1/0
S
192.168.31.1 /32
Internet
---
0/0
When I configured static routes, I was able to communicate with the WRT300N flawlessly, from all/any remote router's network nodes. After setting RIP/RIP2 & even EIGRP (currently set), I can't communicate with the wireless wrt300N. The command, redistribute static on R3, which the wrt300N is connected to directly, didn't do anything.
It seems the router only has a default route set up on it as well.
It's routing table
Type
Network
Port
Next Hop IP
Metric
C
192.168.31.0 /24
Internet
---
0/0
C
192.168.32.0 /24
Vlan 1
---
0/0
S
0.0.0.0 /0
---
192.168.31.1
1/0
S
192.168.31.1 /32
Internet
---
0/0