show VLAN command in GNS3

I need some help. I am using C3640 and C3725 images in GNS3 to simulate switches, but neither of these images seem to support the show vlan command. Other switch commands like spanning-tree and sh vtp status are supported. Has anyone else experienced this?

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

veritas_libertas

It's not surprising. I would pick up some Cisco 2950s. I tried simulating switches in GNS3 and it's VERY limited. If you want to have a great lab for switching than you will need at least three switches.

ajmatson

+1 to Veritas, I did kind of the same but I went with 3550's and loaded the EMI images to get switching commands and some hands on with Layer 3 functions outside of GNS3 until I bought physical routers

d6bmg

As the fellow members suggested, buy two switches. Those would be enough for your labbing. Use then with GNS3 routers.

Zartanasaurus

show vlan-switch