WISM2 install issues

DevilWAH

OK so I have set up the wism2 and have the following output

Service Vlan : 665, Service IP Subnet : 172.20.253.1/255.255.255.248      WLAN
Slot  Controller  Service IP       Management IP    SW Version    Controller Type    Status
----+-----------+----------------+----------------+------------+------------------+---------------
6     1           172.20.253.2     172.20.253.66    7.3.101.0    WS-SVC-WISM-2-K9   Oper-Up


ASH_6506#sh wism module 6 controller 1 status 


WiSM Controller 1 in Slot 6 configured with auto-lag


Operational Status of the Controller : Oper-Up
Service VLAN                         : 665
Service Port                         : 3
Service Port Mac Address             : 6c20.562b.c9e1
Service IP Address                   : 172.20.253.2
Management IP Address                : 172.20.253.66
Software Version                     : 7.3.101.0
Port Channel Number                  : 411
Allowed-vlan list                    : 10,22,667
Native VLAN ID                       : 667
WCP Keep Alive Missed                : 0
ASH_6506#

so all looks fine, and from my desk top I can Ping the management ip

Pinging 172.20.253.66 with 32 bytes of data:Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127


Ping statistics for 172.20.253.66:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 0ms, Maximum = 0ms, Average = 0ms

But if I try to go to the web GUI it times out?
if I use #Session slot X processor 1 I jsut get the auto configuration script.

Any ideas why I cant get to the web interface, no ACL or firewalls between my PC and the CAT6506.

Cheers

DevilWAH

Interestingly if I log on to the core switch (I am installing the 6500 to replace the current core) which the 6500 is hanging off, then I can open an ssh session to the WISM2 management IP.

but although I Can ping the IP from my desk top, I am not able to SSH or get the web page up?

Oh and am I correct

service port is for communications between the chassis and the WISM
management port is for web and console access?