OK so I have set up the wism2 and have the following output
Service Vlan : 665, Service IP Subnet : 172.20.253.1/255.255.255.248 WLAN
Slot Controller Service IP Management IP SW Version Controller Type Status
----+-----------+----------------+----------------+------------+------------------+---------------
6 1 172.20.253.2 172.20.253.66 7.3.101.0 WS-SVC-WISM-2-K9 Oper-Up
ASH_6506#sh wism module 6 controller 1 status
WiSM Controller 1 in Slot 6 configured with auto-lag
Operational Status of the Controller : Oper-Up
Service VLAN : 665
Service Port : 3
Service Port Mac Address : 6c20.562b.c9e1
Service IP Address : 172.20.253.2
Management IP Address : 172.20.253.66
Software Version : 7.3.101.0
Port Channel Number : 411
Allowed-vlan list : 10,22,667
Native VLAN ID : 667
WCP Keep Alive Missed : 0
ASH_6506#
so all looks fine, and from my desk top I can Ping the management ip
Pinging 172.20.253.66 with 32 bytes of data:Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Reply from 172.20.253.66: bytes=32 time<1ms TTL=127
Ping statistics for 172.20.253.66:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 0ms, Maximum = 0ms, Average = 0ms
But if I try to go to the web GUI it times out?
if I use #Session slot X processor 1 I jsut get the auto configuration script.
Any ideas why I cant get to the web interface, no ACL or firewalls between my PC and the CAT6506.
Cheers
