Diagram assistance
yazan84
Member Posts: 20 ■□□□□□□□□□
So I began my studying for MCSA and CCNA :)Today was CCNAstarted with TCP/IP, Switching, Routing, Vlans .. etc needless to say
Question about Routing. I'm working on Cisco Packet tracer and have a diagram consisting of 2 basic networks each divided into smaller networks (servers & workstations)
So after watching tutorial videos and hours of messing around I managed to to have all 4 routers to communicate and ping each other properly.
However, I'm unable to have servers SHOWN IN PIC to ping properly Also nodes on 10.0.0.0/8 network can't communicate with nodes on 6.0.0.0/8 network.
I also attached a pic of router static routing configurations, I did the same on the other network.
Pics:
http://i1151.photobucket.com/albums/o632/larain89/Routing1.jpg
http://i1151.photobucket.com/albums/o632/larain89/Routing2.jpg
Any assistance?
Question about Routing. I'm working on Cisco Packet tracer and have a diagram consisting of 2 basic networks each divided into smaller networks (servers & workstations)
So after watching tutorial videos and hours of messing around I managed to to have all 4 routers to communicate and ping each other properly.
However, I'm unable to have servers SHOWN IN PIC to ping properly Also nodes on 10.0.0.0/8 network can't communicate with nodes on 6.0.0.0/8 network.
I also attached a pic of router static routing configurations, I did the same on the other network.
Pics:
http://i1151.photobucket.com/albums/o632/larain89/Routing1.jpg
http://i1151.photobucket.com/albums/o632/larain89/Routing2.jpg
Any assistance?