show controllers | Begin M4T command

blatini

Is PAS unit # representative of S1/x ? I am running through labs and am very confused about the command. What is a PAS UNnit even?

Carpe Porcus

As in:



M4T: show controller:

PAS unit 8, subunit 0, f/w version 1-25, rev ID 0x2800001, version 2

idb = 0x60B83B40, ds = 0x60B858B8, ssb=0x60B85FFC

Clock mux=0x0, ucmd_ctrl=0x1C, port_status=0x3E

Serial config=0x0, line config=0x200

maxdgram=1524, bufpool=48Kb, 96 particles

DCD=up DSR=up DTR=up RTS=up CTS=up

line state: up

cable type : V.24 (RS-232) DCE cable, received clockrate 9600

[display text omitted]


?

Give this a read:

PA-4T+ Synchronous Serial Port Adapter Installation and Configuration - Attaching the PA-4T+ Interface Cables   [Cisco Port Adapters] - Cisco Systems