Help with Cisco Packet Tracer

I am setting up the network in figure 8.9. CCNA Routing and Switching Study Guide: Exams 100-101, 200-101, and 200-120 - Todd Lammle - Google Books

I configured two 2811 Routers with serial interfaces, and set them up as described in the book.

The issue that I am running into is that

Corp
int s0/0/0
172.168.10.1/30

SF
int s0/0/0
172.168.10.2/30

Interfaces are setup and say that their status is up. However none of the connected routes are appearing on either Corp or SF.

I think I maybe didn't use the right link/there might be a clocking issue.

Could some take a quick look at my SIM? https://www.dropbox.com/s/k88mo2z2f60ob6b/Lammle.pkt

Thanks.

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

jdballinger

Was going to help, but can't get past the password...

Emptypath

I believe I have solved the issue. I was using a Serial DCE connection between them instead of a Serial DTE connection.

Emptypath

jdballinger wrote: »

Was going to help, but can't get past the password...

My bad, it's console and privledged is GlobalNet.

Ltat42a

Clocking needs to be configured on your Corp router S0/1/0 interface, and it is in the wrong subnet.
The SF router interface is in the 172.16.10.0 subnet, the Corp router S0/1/0 interface is in the 172.16.10.4 network.
Remove the IP address from the Corp router S0/0/0 interface and apply that to the S0/1/0 interface, all should be good.