Packet Tracer and HSRP issues

Unidade01Unidade01 Member Posts: 22 ■□□□□□□□□□
in CCNA & CCENT
Hi guys

I'm trying to practice HSRP but i got stuck on this config. Every thing works fine until i config HSRP, after that i can't ping outside the vlans!

Any tips would be appreciated



Thanks
· Share on FacebookShare on Twitter

Comments

  • RouteMyPacketRouteMyPacket Member Posts: 1,104
    Not sure PacketTracer is good for HSRP/VRRP/GLBP? Someone will chime in whose used PT for that
    Modularity and Design Simplicity:

    Think of the 2:00 a.m. test—if you were awakened in the
    middle of the night because of a network problem and had to figure out the
    traffic flows in your network while you were half asleep, could you do it?
    · Share on FacebookShare on Twitter
  • DCDDCD Member Posts: 475 ■■■■□□□□□□
    It works if your not using subinterfaces and VLans, The Vlans I'm still not sure about yet.
    · Share on FacebookShare on Twitter
  • waqarsarwarwaqarsarwar Member Posts: 33 ■■□□□□□□□□
    I tried it too.. I guess there is a bug in a packet tracer!!!!
    · Share on FacebookShare on Twitter
  • Unidade01Unidade01 Member Posts: 22 ■□□□□□□□□□
    thanks for the aswers.

    The fact that PT doesn't handle hsrp very well is disapointing but at least now i know it's not something i was missing in my config
    · Share on FacebookShare on Twitter
  • DCDDCD Member Posts: 475 ■■■■□□□□□□
    waqarsarwar wrote: »
    I tried it too.. I guess there is a bug in a packet tracer!!!!

    I put your config on real equipment and still had the same problem before I could double check it I got called away but I did notice your PC had the VLan 10 ip as the default-gateway. Hopeful I can get back to it in the next day or two.
    · Share on FacebookShare on Twitter
  • waqarsarwarwaqarsarwar Member Posts: 33 ■■□□□□□□□□
    DCD wrote: »
    I put your config on real equipment and still had the same problem before I could double check it I got called away but I did notice your PC had the VLan 10 ip as the default-gateway. Hopeful I can get back to it in the next day or two.

    I changed the default IP to my phantom IP but still had the same problem!
    · Share on FacebookShare on Twitter
  • misterthatguymisterthatguy Registered Users Posts: 1 ■□□□□□□□□□
    I have noticed a few times in pt 6.1 that if you check the version it is using 12. somthing but t his command was not in the IOS until 15 so that could be your problem.
    · Share on FacebookShare on Twitter
Sign In or Register to comment.