Issues with dsl firmware using embeded, when it shouldnt.

So ive done this a few times with no issues but all of a sudden ive hit a bit of a brick wall and dont know where to go next.

I have a 1921 with a VA-DSL-WIC card. Im aware that they use the same dsl firmware as the 887VAs.

So ive uploaded the firmware to flash.

Then ive eneterd config under the vdsl controller to show that so...

controller vdsl 0/0/0
firmware filename flash:vdsl.bin
modem UKfeature under controller vdsl 0/0/0

the vdsl.bin file is in flash

i shut/no shut the vdsl controller

but when i do show controllers vdsl 0/0/0

the firmware shows as using the embeded - im wondering if anyone else has been through this before, and if so any ideas of what i cant try next?

Cheers

Dan

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

asav

Not sure if it's related but you've fallen prey to some really dodgy Cisco docs here (or somebody else's misintrepation of them)

The line "modem UKfeature under controller vdsl 0/0/0" should just read "modem UKfeature".

The "under controller vdsl 0/0/0" part means the command needs to be entered in vdsl interface config mode.

I was caught out by the same thing..