ICND2 - Boson Question Errors?
xintac
Member Posts: 10 ■□□□□□□□□□
in CCNA & CCENT
While using the Boson Software i'm noticing some Grammar errors, no big deal, but i'm stuck on a NetSim question about EIGRP and K values and i think the NetSim setup is wrong.
In the question they manually set the K values to 0 1 1 1 0 0, and you are suppose to use Show Run to figiure that out and know that the K Values are mismatched for the two routers.
However i prefer to use Show IP Protocol to find mismtached K Values.
But if i run a show ip protocol on that same router i see the K values set to "EIGRP Metric weight K1=1, K2=0, K3=1, K4=0, K5=0". The Default K Values for EIGRP.
If you manually set the K values to 0 1 1 1 0 0 shouldn't, show ip protocol, instead say "EIGRP Metric weight K1=1, K2=1, K3=1, K4=0, K5=0"?
Did i miss something?
In the question they manually set the K values to 0 1 1 1 0 0, and you are suppose to use Show Run to figiure that out and know that the K Values are mismatched for the two routers.
However i prefer to use Show IP Protocol to find mismtached K Values.
But if i run a show ip protocol on that same router i see the K values set to "EIGRP Metric weight K1=1, K2=0, K3=1, K4=0, K5=0". The Default K Values for EIGRP.
If you manually set the K values to 0 1 1 1 0 0 shouldn't, show ip protocol, instead say "EIGRP Metric weight K1=1, K2=1, K3=1, K4=0, K5=0"?
Did i miss something?
Comments
-
xintac
Member Posts: 10 ■□□□□□□□□□
I tested it out on GNS3 and the question indeed has an error.
If you use Boson Exam Software for ICND2 be aware that there is an EIGRP Sim Question where the Show IP Protocols for K Values are not showing up correctly.
I was 100% confused when the question said the answer was mismatched K Values for EIGRP but show ip protocols for both routers showed matching K Values.