Etherchannel between cisco and linux server

dellpe

[FONT=&amp]I am trying to configure ether channel between a Huawei [/FONT]S3700-28TP-EI-AC [FONT=&amp]switch and a linux server. I found out that i needed to use lacp as it supports interoperability between different types of hosts. i followed cisco's guide for forming ether channel. However when i do the configuration the ethernet goes down and the device becomes unpingable. [/FONT]

[FONT=&amp]On the Linux side, the configuration looks like this:[/FONT]


cat /etc/modprobe.d/bond.conf
alias bond0 bonding

cat /etc/sysconfig/network-scripts/ifcfg-bond0
DEVICE=bond0
ONBOOT=yes
USERCTL=no
BOOTPROTO=none
NM_CONTROLLED="no"
IPADDR=10.76.161.135
PREFIX=21
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME="System bond0"
BONDING_OPTS="mode=4 miimon=100 lacp_rate=1"

cat /etc/sysconfig/network-scripts/ifcfg-eth0
DEVICE="eth0"
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

cat /etc/sysconfig/network-scripts/ifcfg-eth1
DEVICE="eth1"
BOOTPROTO=none
ONBOOT=yes
MASTER=bond0
SLAVE=yes
USERCTL=no

[Deleted User]

Paste your Switch configuration. Use either show run or show running config or startup-config

W Stewart

In addition to posting the network config, you may want to run ethtool on both interfaces to make sure that the speed and duplex are the same for both links.