VIRL for CCNP

tokamaktokamak Posts: 3Registered Users ■□□□□□□□□□
in CCNP
Is VIRL sufficient by itself for learning CCNP? The academic pricing of $80 for 20 nodes is attractive.

I'm concerned about Cisco learning for the future with real equipment, given than IOS 15.x requires license keys that could get very expensive, depending on feature sets needed.
· Share on FacebookShare on Twitter

Comments

  • fredrikjjfredrikjj Posts: 879Member
    Should be fine. The only possible problem would be some layer 2 switching features that aren't available in the switch image. If that becomes an issue you can just rent some rack time on real switches.
    · Share on FacebookShare on Twitter
  • theodoxatheodoxa Posts: 1,340Member
    VIRL should work fine for Layer 3 at least. The IOS-XE software bundled with it (CSR-1000V) is what is used in most CCIE labs for Layer 3.
    R&S: CCENT → CCNA → CCNP → CCIE [ ]
    Security: CCNA [ ]
    Virtualization: VCA-DCV [ ]
    · Share on FacebookShare on Twitter
  • OctalDumpOctalDump Posts: 1,722Member
    It's fine for CCNP ROUTE. It doesn't have all the features you need for SWITCH, though. CEF and other ASIC dependent features can't really be done properly in a virtual environment (well, not until they put the ASICs on to PCIe cards or something).

    It's the routers that tend to be pricey, since most of the current routers that support IOS 15.2+ have the newer licensing model. You only need the base feature set for ROUTE. But it's the routers that VIRL does well, so this is where you save lots of money.

    So, get some cheap L3 ios 15 Switches (3560, 3750) and the academic VIRL, and you should be fine.
    2017 Goals - Something Cisco, Something Linux, Agile PM
    · Share on FacebookShare on Twitter
Sign In or Register to comment.