Options
Packet Tracer VRF
Alabama
Registered Users Posts: 1 ■□□□□□□□□□
in CCNA & CCENT
Hi Everyone,
I am trying to simulate a network with Cisco Packet Tracer and I need to define different VRFs to isolate different kinds of traffic. So far, I have not been able to create VRF on Routers or layer 3 switches. Whenever I run the command to create vrf I get an error:
Router(config)#ip vrf
^
% Invalid input detected at '^' marker.
Does packet tracer support VRF?
Thank you guys!
I am trying to simulate a network with Cisco Packet Tracer and I need to define different VRFs to isolate different kinds of traffic. So far, I have not been able to create VRF on Routers or layer 3 switches. Whenever I run the command to create vrf I get an error:
Router(config)#ip vrf
^
% Invalid input detected at '^' marker.
Does packet tracer support VRF?
Thank you guys!
Comments
-
Options
aftereffector
Member Posts: 525 ■■■■□□□□□□
Based on your command line output above, I would say the answer is no. Unfortunately PT isn't a 100% solution for labs.CCIE Security - this one might take a while...