Options
No encapsulation type mpls on GNS3 Cisco IOS C3745
mikedcmdva
Registered Users Posts: 3 ■□□□□□□□□□
in CCNP
I set up MPLS on GNS3, however, when I go to create a virtual circuit via the 'xconnect' command, the encapsulation type of 'mpls' is not available. The only type available is 'l2tpv3'. Is this a limitation of the c3745 or?
Comments
-
Optionsmikedcmdva
Registered Users Posts: 3 ■□□□□□□□□□
Wow nobody? Thought the pros were on this board! Haha
-
Options
negru_tudor
Member Posts: 473 ■■■□□□□□□□
Hi
Well MPLS is pretty much a SP track topic. Unless someone over here has experience with MPLS, you might get a faster turnaround asking in the Service Provider section of this forum.2017-2018 goals:
[X] CIPTV2 300-075
[ ] SIP School SSCA
[X] CCNP Switch 300-115 [X] CCNP Route 300-101 [X] CCNP Tshoot 300-135
[ ] LPIC1-101 [ ] LPIC1-102 (wishful thinking) -
Optionsnegru_tudor
Member Posts: 473 ■■■□□□□□□□
Tried this now in GNS3 and a L3 IOU image and it works.
2017-2018 goals:
[X] CIPTV2 300-075
[ ] SIP School SSCA
[X] CCNP Switch 300-115 [X] CCNP Route 300-101 [X] CCNP Tshoot 300-135
[ ] LPIC1-101 [ ] LPIC1-102 (wishful thinking) -
Options
MAC_Addy
Member Posts: 1,740 ■■■■□□□□□□
Are you trying this on a switchport?2017 Certification Goals:
CCNP R/S -
Optionsmikedcmdva
Registered Users Posts: 3 ■□□□□□□□□□
C3745
I used a different IOS image and it worked (C7200). -
Optionsnegru_tudor
Member Posts: 473 ■■■□□□□□□□
You're welcome2017-2018 goals:
[X] CIPTV2 300-075
[ ] SIP School SSCA
[X] CCNP Switch 300-115 [X] CCNP Route 300-101 [X] CCNP Tshoot 300-135
[ ] LPIC1-101 [ ] LPIC1-102 (wishful thinking)
