RSVP

EdTheLadEdTheLad Member Posts: 2,111 ■■■■□□□□□□
I'm trying to setup a traffic engineered mpls trunk but it doesnt come up
due to rsvp signalling being down.
On the interface i config "ip rsvp bandwidth 1000", when i do "show ip rsvp interfaces" i can see this interface has been enabled.But when i do "show ip rsvp neighbor" its blank,no neighbor is detected, two routers are connected via serial with this command on either side.I've check afew sources and my config seems ok.I'm just wondering is it my ios version giving the problem or is there something small im missing?

I've tried it on a 2600 with 12.3 enterprise load, i've also tried it on dynamips
using the c7200-adventerprisek9-mz.124-2.T5.bin load.
Any idea's??
Networking, sometimes i love it, mostly i hate it.Its all about the $$$$

Comments

  • mikej412mikej412 Member Posts: 10,086 ■■■■■■■■■■
    ip cef?

    mpls traffic-eng tunnels? global? interface?
    :mike: Cisco Certifications -- Collect the Entire Set!
  • EdTheLadEdTheLad Member Posts: 2,111 ■■■■□□□□□□
    yep all done,but these should effect a ptp rsvp signalling link?
    Networking, sometimes i love it, mostly i hate it.Its all about the $$$$
  • mikej412mikej412 Member Posts: 10,086 ■■■■■■■■■■
    Hum.... what's the speed of the serial link?
    :mike: Cisco Certifications -- Collect the Entire Set!
  • EdTheLadEdTheLad Member Posts: 2,111 ■■■■□□□□□□
    128k,ok i got it working.I was under the impression that the signalling link would come up over the ptp link with our without the tunnel configured.Obviously not, strange design for me as dont see why setting up a signalling link should be dependent on messages running over the link, anyway i have to get used to ciscos approach.
    Thanks..
    Networking, sometimes i love it, mostly i hate it.Its all about the $$$$
Sign In or Register to comment.