Options

Can't ping interface

GomjabberGomjabber Member Posts: 19 ■□□□□□□□□□
in CCNA & CCENT
I'm getting started with my home lab setup, and already am running into snags.

I have a workstation with 10.0.0.10/24 assigned. It is connected to fa0/0 on a 2960 router with 10.0.0.1/24. On Fa0/1 I have 172.16.0.1/30. Both interfaces are up/up. From the workstation, I can ping 10.0.0.1, but not 172.16.0.1.

What is wrong?
· Share on FacebookShare on Twitter

Comments

  • Options
    dontstopdontstop Member Posts: 579 ■■■■□□□□□□
    What's the default gateway of the PC?

    2960 Router? The only 2960 that I know of is a 24/48 ports 2 switch that has some basic Layer 3 routing capabilities. What's the exact model of your 2960 "show version" and can you paste the "show run"?
    · Share on FacebookShare on Twitter
  • Options
    GomjabberGomjabber Member Posts: 19 ■□□□□□□□□□
    Hey thanks for the reply dontstop.

    The router is an 1841, my bad. I do have 2 Catalyst 2960 series PD switches though. I haven't been using them too much yet, as most of my labs have been using the 1841's.

    Default gateway is 10.0.0.1.

    When I was confirming my default gateway I decided I should turn off my wifi and afterwards, boom I could ping fa0/1.

    Hopefully I'll get better as time goes on.

    Thanks.
    · Share on FacebookShare on Twitter
  • Options
    DCDDCD Member Posts: 473 ■■■■□□□□□□
    Need a "Show IP interface Brief" and "Show IP Route" and the PC IP configuration. The PC is the mostly likely issue
    · Share on FacebookShare on Twitter
Sign In or Register to comment.