Conflicting VLAN commands Todd vs Cisco Press

I am getting confused with VLAN commands and how to create them because Todd, and Cisco describe two different methods for a 29xx switch. I am worried that the Cisco test will only accept one way, and mark my answer wrong, so which way is the correct way, or which way is the “Cisco Way”. Here are a few examples.

-=Todd=-
En
Config t
Vlan 2
Name lab

en
Config t
Int f0/2
Switchport access vlan 2

-=Cisco=-
en
vlan database
vlan 2 name barney 2
config t
int f0/4
switchport mode access
switchport acces vlan 2
int f0/6
switchport mode access
switchport access vlan 2

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

wait2dominate

As others have stated before, the test will only allow for one way to be inputed. Which way....I dunno

As for which way is correct....I have used both before....the vlan database on a 2900 switch and the conf t method on a 2950 switch.....

dtlokee

VLAN database configuration mode is being removed and should not be used if the switch IOS supprts VLAN configuration mode (that's the rotuer(config-vlan)# one that you access from global config) You cannot create extended range VLANS in the vlan database mode.

you should be familiar with both, but I would use the vlan configuration mode when possible:

enable
config t
vlan 2
name lab

wait2dominate

dtlokee wrote:

VLAN database configuration mode is being removed and should not be used if the switch IOS supprts VLAN configuration mode (that's the rotuer(config-vlan)# one that you access from global config) You cannot create extended range VLANS in the vlan database mode.

you should be familiar with both, but I would use the vlan configuration mode when possible:

enable
config t
vlan 2
name lab

The other huge benifit of this method is when you are assigning multiple ports to the samae VLAN, using the range keyword:) Makes life happy.

LOkrasa

Great question... I was searching for the answer to this too.

datchcha

Ok thanks. Which method did you use when your CCNA.

wait2dominate

datchcha wrote:

Ok thanks. Which method did you use when your CCNA.

Not sure if it violates NDA to post it or not, so I'd say just know both. It's only a few more lines anyways.

Based off the change to the exam, and IOS releases at the date of new exam release, I'm sure the 802 will use the conf t method

Netstudent

If this comes up in an exam, it will most likely be a sim. Where you would have to configure vlans or something. If one method comes back and gives you an error, then you know it's the other method. Also if it is a vlan sim, then most likely the show vlan command will be supported. So whatever method you use, just do your show commands to make sure you have added the vlans with the correct names and numbers.

If it is a mulitple choice Q, then choose one method or the other. If both methods are in the answer choice and it says choose the best option, well then you better use the modern method and not the phased out method. If this was to arise, they would be testing your ability to recognize current standards i would guess.

I don't think cisco will leave an opened ended question when they know some methodologies are being phased out.

LOkrasa

Here is the message I get when doing the command "vlan database" on my 2950 with the latest IOS...

2950A#vlan database
% Warning: It is recommended to configure VLAN from config mode,
  as VLAN database mode is being deprecated. Please consult user
  documentation for configuring VTP/VLAN in config mode.

I guess config would be the way to go....