Connect Router to Router via DCE/DTE cable
OK I am trying to hook 2 2501 Routers together with a DCE/DTE cable and I can't seems to get the Protocol to change to "UP" Anyone see anything wrong?
Show Interface Serial0 on RouterA
RouterA#show interface serial0
Serial0 is up, line protocol is down
Hardware is HD64570
Internet address is 192.168.22.5/24
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output 00:00:09, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0 (size/max/drops); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/2/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
17 packets output, 664 bytes, 0 underruns
0 output errors, 0 collisions, 20 interface resets
0 output buffer failures, 0 output buffers swapped out
19 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
RouterA#
Show IP Interface Brief
RouterA#show ip interface brief
Interface IP-Address OK? Method Status Protocol
Ethernet0 192.168.2.50 YES NVRAM up up
Serial0 192.168.22.5 YES manual up down
Serial1 unassigned YES unset administratively down down
RouterA#
I can't ping it or anything.
Thanks!
