Autoqos interoperability with Mitel?

mzinzmzinz Posts: 328Member
in CCNP Security
Will the Autoqos commands work, even when Cisco gear isn't being used (Mitel, specifically).

I know that Mitel will use RTP for its voice traffic, but I'm not so sure about signaling/control protocols.

Anyone know about this?
_______LAB________
2x 2950
2x 3550
2x 2650XM
2x 3640
1x 2801
· Share on FacebookShare on Twitter

Comments

  • dtlokeedtlokee Posts: 2,381Member
    Which part of AutoQoS? If applied to an access port it will use CDP to make sure there is a phone connected and then apply the corect port trust settings. You may be better off hardcoding the settings you want on the interface (assuming the phone can do the marking.)
    The only easy day was yesterday!
    · Share on FacebookShare on Twitter
  • mzinzmzinz Posts: 328Member
    dtlokee wrote:
    Which part of AutoQoS? If applied to an access port it will use CDP to make sure there is a phone connected and then apply the corect port trust settings. You may be better off hardcoding the settings you want on the interface (assuming the phone can do the marking.)

    I'm trying to set up the simplest QoS possible -- Just tagging data as it goes out. What would be the best way to accomplish that?
    _______LAB________
    2x 2950
    2x 3550
    2x 2650XM
    2x 3640
    1x 2801
    · Share on FacebookShare on Twitter
Sign In or Register to comment.