Options

pix help(newb)

qplayedqplayed Member Posts: 303
in CCNP Security
Hi guys after a night of screwing around with a bad image i decided to upgrade to 7.x
Cisco told me i could use my existing license to 7.x :)

anyway i've finally got 7.x loaded but i am not able to run
copy tftp flash

here is what i get
pixfirewall# copy tftp flash

Address or name of remote host [10.0.0.1]?

Source filename [pix722.bin]?

Destination filename [pix722.bin]?

Accessing tftp://10.0.0.1/pix722.bin...
%Error opening tftp://10.0.0.1/pix722.bin (No such device)

this is from a clean install(i used erasedisk.bin)

i've also set ethernet 0's ip address 10.0.0.2 
pixfirewall# ping 10.0.0.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.1, timeout is 2 seconds:
No route to host 10.0.0.1

Success rate is 0 percent (0/1)

i tried to add a route(guessing) 
pixfirewall(config)# route ?

configure mode commands/options:
Current available interface(s):
pixfirewall(config)# route

if i don't get the image to flash it just keeps on a reboot loop
which is exactly what the cisco docs had said ...


any help is appreciated
[/code]
If you cannot express in a sentence or two what
you intend to get across, then it is not focused
well enough.
—Charles Osgood, TV commentator
· Share on FacebookShare on Twitter

Comments

Sign In or Register to comment.