more frame-relay switch fun

i'm geting this error message when typing in a route statment

'route command not allowed between two DTE interfaces'

here's my config - there is 4 routers, 3 are full mesh and there is a point-to-point for the other

ip subnet-zero
no ip domain-lookup
frame-relay switching

int s0/0
no ip address
encapsulation frame-relay
frame-relay route 106 interface s0/2 105
frame-relay route 108 interface s0/3 104
frame-relay route 107 interface s0/1 101
clockrate 800000
logging event subif-link-status
logging event dlci-status-change

int s0/1
no ip address
encapsulation frame-relay
frame-relay route 101 interface s0/0 107
frame-relay route 102 interface s0/3 103
clockrate 800000
logging event subif-link-status
logging event dlci-status-change

int s0/2
no ip address
encapsulation frame-relay
frame-relay route 105 interface s0/0 106
clockrate 800000
logging event subif-link-status
logging event dlci-status-change

int s0/3
no ip address
encapsulation frame-relay
frame-relay route 104 interface s0/0 108
frame-relay route 103 interface s0/1 102
clockrate 800000
logging event subif-link-status
logging event dlci-status-change

Find more posts tagged with

Save $250 on 2025 certification boot camps from Infosec!

Book now with code EOY2025

Button

Comments

mikej412

Set the frame relay interface type to DCE on the router acting as the frame relay switch. This is seperate from the DCE/DTE end of the cable if you're using a back-to-back cable and setting the clock rate.

frame-relay intf-type dce

aueddonline

cheer mike, I can go to bed now