2950 Config

I know I am just over looking something simple (I am at wits end dealing with this http://www.techexams.net/forums/viewtopic.php?t=41305), but I can't get a PC to communicate through a 2950 to a WRT300N, then out to the internet. The WRT300N is addressed 10.1.1.1 and the switch is 10.1.1.2. The router hands out DHCP starting at 10.1.1.6 - 10.1.1.10. Masks are all set to 255.255.255.0.

The 2950 is uplinking via Fa0/24 to port 0/1 on the WRT300N.

All ports are a memeber of VLAN 1 and are set to access mode.

What are some configs you guys use when setting up a Cisco switch as an access layer switch in your homes?

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

ilcram19-2

for the pc/network devices only ports portfast on the interfaces

malcybood

boostinbadger wrote:

I know I am just over looking something simple (I am at wits end dealing with this http://www.techexams.net/forums/viewtopic.php?t=41305), but I can't get a PC to communicate through a 2950 to a WRT300N, then out to the internet. The WRT300N is addressed 10.1.1.1 and the switch is 10.1.1.2. The router hands out DHCP starting at 10.1.1.6 - 10.1.1.10. Masks are all set to 255.255.255.0.

The 2950 is uplinking via Fa0/24 to port 0/1 on the WRT300N.

All ports are a memeber of VLAN 1 and are set to access mode.

What are some configs you guys use when setting up a Cisco switch as an access layer switch in your homes?

Please post your full config from the 2950

boostinbadger

Just as I thought...it was a stupid mistake. L1 problem.

Should the port that is uplinked to the WRT300N be configured in a particular way? Right now it is configured for access.