Options
Cisco 1310 bridge password recovery
Hello.
I bought a Cisco 1310 bridge with a power injector from Ebay and I am trying to set it up. The seller didn't provide the password or the IP address. I tried to console to it, but was unsuccessful. I tried different bit rate and flow control combinations and nothing worked. I attached the bridge to a switch and did a cdp and it showed up with an ip address. I pinged it and it was successful. I tried login to it using default username and password (Cisco), but that didn't work either.
I looked up the 1310 bridge and Cisco says that you have to have web access or console access in order to reset the password.
Am I out of luck? or is there another way to get around this problem
Thank You
I bought a Cisco 1310 bridge with a power injector from Ebay and I am trying to set it up. The seller didn't provide the password or the IP address. I tried to console to it, but was unsuccessful. I tried different bit rate and flow control combinations and nothing worked. I attached the bridge to a switch and did a cdp and it showed up with an ip address. I pinged it and it was successful. I tried login to it using default username and password (Cisco), but that didn't work either.
I looked up the 1310 bridge and Cisco says that you have to have web access or console access in order to reset the password.
Am I out of luck? or is there another way to get around this problem
Thank You
Comments
-
Options
tiersten
Member Posts: 4,505
You need to be able to use the console to reset the unit back to factory defaults. The 1310 doesn't have the mode button on the other units.
Are you sure your console cable is correct? -
Optionsfid500
Member Posts: 71 ■■□□□□□□□□
Cable is not the issue because I can console to my other switches and routers