Options
call signalling ? -- please help
softestplease
Member Posts: 14 ■□□□□□□□□□
Hi Expert...
have the topology like
2000
2001
2002
RouterA
RouterB
RouterC
10.0.0.1
10.0.0.2
10.0.0.3
I tried to call from RouterA to RouterC, the config I have so far is
dial-peer voice 2002 voip
destination-pattern 2002
session target ipv4:10.0.0.2 (RouterB IP)
codec g711ulaw
with the config above.. the call from RouterA to RouterC was unsuccessfull, do I need to use Voip Signalling protocol (like H.323) or maybe I need to configure something on RouterB to be able to send the call from RouterA to reach RouterC?
The only requirement for this case is only.. eigrp to be used to route across the link....
Thanks in advance
have the topology like
2000
2001
2002
RouterA
RouterB
RouterC
10.0.0.1
10.0.0.2
10.0.0.3
I tried to call from RouterA to RouterC, the config I have so far is
dial-peer voice 2002 voip
destination-pattern 2002
session target ipv4:10.0.0.2 (RouterB IP)
codec g711ulaw
with the config above.. the call from RouterA to RouterC was unsuccessfull, do I need to use Voip Signalling protocol (like H.323) or maybe I need to configure something on RouterB to be able to send the call from RouterA to reach RouterC?
The only requirement for this case is only.. eigrp to be used to route across the link....
Thanks in advance
Comments
-
Optionsmikem2te
Member Posts: 407
Why are you setting the destination to be router B rather than router C? Provided there is IP connectivity between A and C then that should be fine.Blog : http://www.caerffili.co.uk/
Previous : Passed Configuring Microsoft Office SharePoint Server 2007 (70-630)
Currently : EIGRP & OSPF
Next : CCNP Route