Options
GNS3 and CCA
aleruri
Member Posts: 2 ■□□□□□□□□□
Hi all,
This is my first post so please be nice
.
I have built a CCNA voice lab using GNS3 and VMWare. I am emulating two 3700 routers connected via a WAN link. I am also using VMWare to emulate the IP soft phones (installed on virtual windows xp), so far I have been able to practice plenty of things. The last thing that I tried to do was to install CCA in my local machine (which I have connected to one of the simulated routers through a Microsoft loopback interface). I just wanted to see how the topology and the front view looked like. However, after setting everything up, CCA connects to the router but I got a message saying "Device not supported" and it does really show anything.
Anyone has done this before? Any luck?
Thanks.
This is my first post so please be nice
.I have built a CCNA voice lab using GNS3 and VMWare. I am emulating two 3700 routers connected via a WAN link. I am also using VMWare to emulate the IP soft phones (installed on virtual windows xp), so far I have been able to practice plenty of things. The last thing that I tried to do was to install CCA in my local machine (which I have connected to one of the simulated routers through a Microsoft loopback interface). I just wanted to see how the topology and the front view looked like. However, after setting everything up, CCA connects to the router but I got a message saying "Device not supported" and it does really show anything.
Anyone has done this before? Any luck?
Thanks.
Comments
-
Options
pitviper
Member Posts: 1,376 ■■■■■■■□□□
Welcome to the madness!! Sounds like you have a nice little setup there!
The CCA only supports the UC520/40/60 and SR520 small business class platforms. Unfortunately, there is no way to emulate these devices (at least not yet).CCNP:Collaboration, CCNP:R&S, CCNA:S, CCNA:V, CCNA, CCENT