Cisco 2501
vsousa
Member Posts: 13 ■□□□□□□□□□
in CCNA & CCENT
Hey Everyone,
I just purchased a Cisco 2501 router and 2900 series switch. When I open up my hyperterminal, there are (blank screen) no characters displaying on the screen. The settings are 9600, 8, none, 1, none. I am also using Secure CRT and the same thing happens. I know the switch works because I bought it from a friend of mind, and I saw him use it. I am new to this, so any help would be appreciated.
I just purchased a Cisco 2501 router and 2900 series switch. When I open up my hyperterminal, there are (blank screen) no characters displaying on the screen. The settings are 9600, 8, none, 1, none. I am also using Secure CRT and the same thing happens. I know the switch works because I bought it from a friend of mind, and I saw him use it. I am new to this, so any help would be appreciated.
Comments
-
hjengo
Member Posts: 3 ■□□□□□□□□□
You need a roll-over UTP cable to connect your PC to the router's console port.