Options
VLAN question
tonydotigr
Member Posts: 129
in CCNA & CCENT
Could the following commands be used to add VLAN 50 to a database?
vtp server
switchport access vlan 50
TIA
vtp server
switchport access vlan 50
TIA
Comments
-
Optionstonydotigr
Member Posts: 129
Have another VLAN related question.
When applying the following statement "switchport trunk encapsulation dot1q", do I need to be in global config mode or interface mode.
TIA -
Optionstonydotigr
Member Posts: 129
I have one LAST question with VLANs, I promise!!!!
Would the following commands properly carry traffic from all VLANs to a directly connected switch.
- switchport mode trunk
- switchport access vlan all
TIA -
Options
darkuser
Member Posts: 620 ■■■□□□□□□□
-
OptionsGeeljire
Member Posts: 3 ■□□□□□□□□□
I did the Vlan, part of CCNA theoratically, bcuz the place where i was training was short on switches.
i think i understand, but u can never know, unless u've tried it out practically, do u guyz think using a simulator could substitute for lack of hands on experience, u know just to get the feel of it ??? -
Options
Webmaster
Admin Posts: 10,292 Admin
Yeah, a simulator is better than nothing, much better actually as they've become pretty advanced. Still not really hands-on, but it helps a lot with remembering those commands and when and where to use them. -
Optionsmedic
Member Posts: 116 ■■■□□□□□□□
If actual equipment is not available, I highly recommend the Cisco CCNA Network Simulator by Cisco Press/Boson.
