NewTecher wrote: »
Do layer models / architectures enable faster data transmission?
Switch fills the CAM table based on destination MAC addresses, right?
Forsaken_GA wrote: »
Yes and No. They're just frameworks to design by. A properly designed network will generally function better than a badly designed one. The trick is that a properly designed network is dependent on the specification of the needs of the business implementing it. For example, I could have the exact same layout for two different networks. If one of them is only needing to move bulk traffic around, it'll perform fine.
If I took that same layout and all of a sudden I needed to support voice and video in addition to bulk transfer, it would perform badly without some tweaking.
network design best practices are kind of like the pirate code - they're guidelines. There are no hard and fast rules, and what you implement depends entirely on your needs.
And then there's the fact that I could follow every best practice in the book in the design. But if I use crappy or old hardware, it's not going to go faster. Making the network go faster involves a metric fragton of variables.
Nope, source. When you transmit a frame, you have a source MAC address, and a destination MAC address.
When you transmit a frame to the switch, it looks at the source MAC, and notes that 'this source MAC can be found on this port".
Then it looks at the destination MAC. If it finds a match in the CAM table, it sends it out that port. If it doesn't, then it broadcasts the frame out all ports except the one that it was received on.
When the real destination responds, the switch notes that (again, it sees the source mac on the incoming frame, notes which port it came from), and from then on (or until the entry ages out), the two nodes can communicate directly without the need for further broadcasts.
It's impossible to populate based on destination. In order to populate by destination, you'd have to know where they are ahead of time, and if you already know that, it's already populated. It's a chicken and egg problem. So instead, it applies the shotgun method and just yells at everyone, and then makes a note about who responds.
NewTecher wrote: »
another quick one to confirm it, can frame switch between different network implementations..without any bigger/important changes?