Which Show command shows you the "clock rate"?

SurferdudeHBSurferdudeHB Member Posts: 199 ■■■□□□□□□□
I use the Show controller to see DTE or DCE but I can't find the Show command that tells you if the clock rate has been set to the serial port. Thx.

I'm working on a lab and Router 1 and Router two are not pinging each others.

Serial1/1 172.22.2.2 YES unset up down

I checked the clock rate, RIP2 is on, not sure where else to look..

Comments

  • cisco_kiddcisco_kidd Member Posts: 64 ■■□□□□□□□□
    I use the Show controller to see DTE or DCE but I can't find the Show command that tells you if the clock rate has been set to the serial port. Thx.

    I'm working on a lab and Router 1 and Router two are not pinging each others.

    Serial1/1 172.22.2.2 YES unset up down

    I checked the clock rate, RIP2 is on, not sure where else to look..

    show int <interface>
  • Todd BurrellTodd Burrell Member Posts: 280
    I'm pretty sure it will also show up with the SHOW RUNNING-CONFIG command, or SHOW RUN for short.
  • EverlifeEverlife Member Posts: 253 ■■■□□□□□□□
    The show controllers command will display the clock rate. You need to make sure you run the command from the router that contains the interface you set the clock rate on.
Sign In or Register to comment.