fast help required :-)

tux · October 2005

Set up RIPV2

enable
conf t
router rip
network x.x.x.x

correct?

does it need a 'version2' in there somewhere?

plus

configuring a switch to join the same vtp domain as another switch and become a vtp client? howto via cli?

These where easy last week, on the day of the test my mind is blank.
Thanks in advance

kyle.tk · October 2005

You don't need version 2. But if you want it to run in version 2 then you would type it right after you type router rip. Like this:

enable
conf t
router rip
[b]version 2[/b]
network x.x.x.x

SV · October 2005

tux wrote:

configuring a switch to join the same vtp domain as another switch and become a vtp client? howto via cli?

# config t
(config)# vtp domain domain_name (domain_name used in VTP server)
(config)# vtp mode client

darkuser · October 2005

http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/np1_c/1cprt1/1crip.htm

fast help required :-)

Comments