Options
Teho help
THE.ALFISTI
Member Posts: 11 ■□□□□□□□□□
Hi team
Thanks for every one for knowledge sharing.
I'm doing my best effort on voice with yours help and à cisco book.
In my work i'm blocked on the way to configure Teho on cisco call manager .
If any helps thanks in advance
Thanks for every one for knowledge sharing.
I'm doing my best effort on voice with yours help and à cisco book.
In my work i'm blocked on the way to configure Teho on cisco call manager .
If any helps thanks in advance
Comments
-
Options
shodown
Member Posts: 2,271
THE.ALFISTI wrote: »Hi team
Thanks for every one for knowledge sharing.
I'm doing my best effort on voice with yours help and à cisco book.
In my work i'm blocked on the way to configure Teho on cisco call manager .
If any helps thanks in advance
This is one of those depends questions.
Do you have E164 deployed
Have you checked restricitons in the country you plan on doing TEHO in
Anyway to get down to it. You can setup route patterns that have area code to the area of your PRI and you can setup those patterns to use the gateway you specified which should be in the same area as the area code. Then you have to give everyone access to that partition to make use of that call. Also you may have to manipulate the caller ID as that PRI maynot accept those calls outbound with wrong caller ID.Currently Reading
CUCM SRND 9x/10, UCCX SRND 10x, QOS SRND, SIP Trunking Guide, anything contact center related