txload 255/255 but no traffic

Hi all,


I am experiencing a strange problem with a ASR1002 router that I just installed.thsi is a point to point link .the link is working but for some reason the txload on interface g0/0/0 show 255/255 even though there is no traffic going over to this router.



Thanks in advance for any suggestions !!!



Please see the below interface status for both router.

Router#sh int gi0/0/3

GigabitEthernet0/0/3 is up, line protocol is up

  Hardware is 4XGE-BUILT-IN, address is a493.4c98.db03 (bia a493.4c98.db03)

  Description: "100Mbps LINK"

  Internet address is 10.172.20.110/30

  MTU 9100 bytes, BW 100000 Kbit/sec, DLY 100 usec,

     reliability 255/255, txload 255/255, rxload 1/255

  Encapsulation ARPA, loopback not set

  Keepalive not supported

  Full Duplex, 100Mbps, link type is auto, media type is T

  output flow-control is on, input flow-control is on

  ARP type: ARPA, ARP Timeout 04:00:00

  Last input 00:46:49, output 00:00:29, output hang never

  Last clearing of "show interface" counters never

  Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0

  Queueing strategy: fifo

  Output queue: 0/40 (size/max)

  5 minute input rate 7000 bits/sec, 4 packets/sec

  5 minute output rate 5000 bits/sec, 2 packets/sec

     17890 packets input, 9074660 bytes, 0 no buffer

     Received 0 broadcasts (0 IP multicasts)

     0 runts, 0 giants, 0 throttles

     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

     0 watchdog, 7503 multicast, 0 pause input

     10137 packets output, 2803120 bytes, 0 underruns

     0 output errors, 0 collisions, 2 interface resets

     0 unknown protocol drops

     0 babbles, 0 late collision, 0 deferred

     0 lost carrier, 0 no carrier, 0 pause output

     0 output buffer failures, 0 output buffers swapped out

Router#

-------------------------------------------------------------------------------------------------------------------------------------------------------------

RP/0/RSP0/CPU0:ASR-9010#sh int Gi0/0/0/13

Tue Oct 30 11:32:10.104 ist

GigabitEthernet0/0/0/13 is up, line protocol is up

  Interface state transitions: 11

  Hardware is GigabitEthernet, address is 18ef.63e8.6ce7 (bia 18ef.63e8.6ce7)

  Description: "100Mbps , Gi0/0/0/13"

  Internet address is 10.172.20.109/30

  MTU 9114 bytes, BW 100000 Kbit (Max: 100000 Kbit)

     reliability 253/255, txload 0/255, rxload 0/255

  Encapsulation ARPA,

  Full-duplex, 100Mb/s, THD, link type is force-up

  output flow control is off, input flow control is off

  loopback not set,

  ARP type ARPA, ARP timeout 04:00:00

  Last input 00:00:00, output 00:00:00

  Last clearing of "show interface" counters 22w6d

  30 second input rate 3000 bits/sec, 0 packets/sec

  30 second output rate 8000 bits/sec, 3 packets/sec

     665819 packets input, 159562042 bytes, 5896 total input drops

     1 drops for unrecognized upper-level protocol

     Received 21 broadcast packets, 99558 multicast packets

              350 runts, 1154 giants, 0 throttles, 0 parity

     5895 input errors, 2545 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

     2154457 packets output, 748147945 bytes, 0 total output drops

     Output 14647 broadcast packets, 1490193 multicast packets

     0 output errors, 0 underruns, 0 applique, 0 resets

     0 output buffer failures, 0 output buffers swapped out

     11 carrier transitions

 

RP/0/RSP0/CPU0:ASR-9010#

please reply..........