Options
VG224 pots dial peers
Trifidw
Member Posts: 281
Hello,
If you have a VG224 with these 2 dial peers and no other configuration (no callmanager) should they be able to call each other?
voice-port 2/0
!
voice-port 2/1
!
dial-peer voice 1000 pots
destination-pattern 1000
port 2/0
!
dial-peer voice 1001 pots
destination-pattern 1001
port 2/1
Or do you need additional dial peers/configuration? I can't quite see where it becomes a VoIP call. I also can't see it being a analogue call between the 2 because it's not a PBX etc.
Thanks.
If you have a VG224 with these 2 dial peers and no other configuration (no callmanager) should they be able to call each other?
voice-port 2/0
!
voice-port 2/1
!
dial-peer voice 1000 pots
destination-pattern 1000
port 2/0
!
dial-peer voice 1001 pots
destination-pattern 1001
port 2/1
Or do you need additional dial peers/configuration? I can't quite see where it becomes a VoIP call. I also can't see it being a analogue call between the 2 because it's not a PBX etc.
Thanks.
Comments
-
Options
pitviper
Member Posts: 1,376 ■■■■■■■□□□
Yeah, I think that’ll work as is. It would be an end-to-end analog call since there is no codec manipulation/transcoding.CCNP:Collaboration, CCNP:R&S, CCNA:S, CCNA:V, CCNA, CCENT -
OptionsGT-Rob
Member Posts: 1,090
Although I have never tried, I would guess not. Something needs to process the call, set it up, tear it down. Where is the dial tone coming from?
-
Optionspitviper
Member Posts: 1,376 ■■■■■■■□□□
It’s an analog call – should work fine. You get dial-tone from an FXS port with no config on it.
From “Dial Peer Configuration Examples” on Cisco.com
CCNP:Collaboration, CCNP:R&S, CCNA:S, CCNA:V, CCNA, CCENT