vlans 2950 switch

nathan8nathan8 Member Posts: 12 ■□□□□□□□□□
when i make 3 vlans and then go into them one at a time and type the no shutdown command, only 1 of them is up and the others are down.
then i go into one of the other vlans that is down and type no shutdown and the one that was up changes to down.

they all have the correct ip addresses

could someone help

Comments

  • JuddJudd Member Posts: 132
    Just throwing this out here, and could be completely wrong, but I had a similar issue with a 2950 in a lab once and realized that patch cables had to populate at least one port in each vlan for the line to stay up.
  • keenonkeenon Member Posts: 1,922 ■■■■□□□□□□
    nathan8 wrote:

    they all have the correct ip addresses

    per you post it sounds like your trying to user 3 vlan interfaces on the switch(trying to use it as a mls)
    your only going to be able to have 1 active vlan interface for management
    Become the stainless steel sharp knife in a drawer full of rusty spoons
Sign In or Register to comment.