Options
ASA IPv6 to IPV4 Design
triki
Member Posts: 20 ■□□□□□□□□□
Hello TE community ,I have to come up with an IPV6 to IPV4 design using two Cisco ASA 5540 that are configured as active active failover for redundancy and as my gateway.I have been researching this design and so far my research shows that the asa does not support most of the V6 to V4 migration designs such as ipv6ip tunnels GRE,6to4 ISATAP ,and IPV6-IPV4 (Network Address Translation – Protocol Translation).DO you guys have any suggestions as to how I can implement this using the cisco ASA ,I greatly appreciate your response TE
Comments
-
Optionstriki
Member Posts: 20 ■□□□□□□□□□
Okay TE community I contacted Cisco and I was informed that version 9.0 supports NAT PT