Options

Can you trunk 1900 and 2950 with 3500 series

chinamanchinaman Inactive Imported Users Posts: 167
in CCNA & CCENT
Hello guys,

I just want to ask something regarding trunking, I read on the sybex book that 1900 is for isl and 2950 dot 1q. However

Is it possible to connect the two using layer 3 switching like 3500 series
which support isl and dot 1q.

Ex. vlan A port 2-3 are in 1900
vlan B port 4-5 are in 2950

Can these two see each other
· Share on FacebookShare on Twitter

Comments

  • Options
    HumperHumper Member Posts: 647
    I believe the 1900 supports dot1q doesnt it?
    Now working full time!
    · Share on FacebookShare on Twitter
  • Options
    porengoporengo Member Posts: 343
    ModemHumper wrote:
    I believe the 1900 supports dot1q doesnt it?

    The 1900's only support isl. However, the 2900XL's will support both isl and dot1q.
    chinaman wrote:
    Is it possible to connect the two using layer 3 switching like 3500 series
    which support isl and dot 1q.

    No, it either has to be isl or dot1q. You can't mix the two.
    · Share on FacebookShare on Twitter
  • Options
    SVSV Member Posts: 166
    chinaman wrote:
    I just want to ask something regarding trunking, I read on the sybex book that 1900 is for isl and 2950 dot 1q. However

    Is it possible to connect the two using layer 3 switching like 3500 series
    which support isl and dot 1q.

    "ISL (Cisco proprietary protocol, and not supported by the 2940 or 2950 series switches)" (http://www.cisco.com/warp/public/473/50.shtml)

    Though I am not 100% sure about the trunking connections supported by these switches, I have a doubt. Since a device that supports both trunking connections is going to be in between, won't the whole setup work.

    Ex:
    1900 (1) <
    > (1)3500(12) <
    > (12) 2950

    What will happen if the trunk ports, ie both 1s are using ISL, and both trunk ports 12s are going to use dot1q?
    Isn't the type of trunk connection attached to a port?

    What if we want to create a VLAN with few 1900s that uses the Cisco proprietary protocol, and few non-cisco switches that uses 802.1Q ?

    Thanks,

    Shiju
    Life is a journey...
    · Share on FacebookShare on Twitter
  • Options
    pannupanditpannupandit Member Posts: 92 ■■□□□□□□□□
    WELL U NEED TO USE ISL as the trunking protocol as 1900 support only ISL and 2900 series supports both. So configure ISl on both swithes. You will be successful in ur practical.
    pannu
    · Share on FacebookShare on Twitter
Sign In or Register to comment.