Options

CCP - How much is enough?

sendalotsendalot Member Posts: 328
in CCNA Security
Apparently, 640-554 puts heavy emphasis on CCP.


So how much is enough?

I know basic NAT, ACL, routing and have completed a IPsec site-to-site tunnel (verified connectivity as well).


Do I have to know everything inside out?


Thanks.
· Share on FacebookShare on Twitter

Comments

  • Options
    blackberryblackberry Member Posts: 59 ■■□□□□□□□□
    sendalot wrote: »
    Apparently, 640-554 puts heavy emphasis on CCP.


    So how much is enough?

    I know basic NAT, ACL, routing and have completed a IPsec site-to-site tunnel (verified connectivity as well).


    Do I have to know everything inside out?


    Thanks.

    add zone based firewalls
    · Share on FacebookShare on Twitter
  • Options
    sendalotsendalot Member Posts: 328
    what was your exam experience? did you ace it on 1st try?
    thanks.
    · Share on FacebookShare on Twitter
  • Options
    alan2308alan2308 Member Posts: 1,854 ■■■■■■■■□□
    Check the exam topics on the Cisco site. Know how to do everything listed there. You don't have to be an expert, but you should be able to make your way through the menus and have a decent idea what you're going to do when you find the screen you're looking for. Also note tasks where there's more than one way of doing something, you may find your preferred method greyed out in the exam.
    Facebook LinkedIn Twitter
    · Share on FacebookShare on Twitter
  • Options
    rowelldrowelld Member Posts: 176
    Assume you'd need to configure everything through CCP
    Visit my blog: http://www.packet6.com - I'm on the CWNE journey!
    · Share on FacebookShare on Twitter
  • Options
    RouteMyPacketRouteMyPacket Member Posts: 1,104
    CCNA Security is all CCP as far as configuration is concerned. ASDM/IME will come into play at the CCNP level.

    640-554 IINS - IT Certification and Career Paths - Cisco Systems
    Modularity and Design Simplicity:

    Think of the 2:00 a.m. test—if you were awakened in the
    middle of the night because of a network problem and had to figure out the
    traffic flows in your network while you were half asleep, could you do it?
    · Share on FacebookShare on Twitter
  • Options
    sendalotsendalot Member Posts: 328
    I passed both ICNDs on several attempts. I hope to pass security without much reattempt dramas.

    Thanks you all for the tips.
    · Share on FacebookShare on Twitter
  • Options
    atorvenatorven Member Posts: 319
    Let's flip the question, how much is enough on the CLI? So far I'm doing everything from the CLI.
    · Share on FacebookShare on Twitter
  • Options
    RouteMyPacketRouteMyPacket Member Posts: 1,104
    atorven wrote: »
    Let's flip the question, how much is enough on the CLI? So far I'm doing everything from the CLI.

    There is no CLI from what I remember? CCP was used for everything. You can setup a good lab within GNS3 with loopback adapters and then connect to them with CCP and do everything you need.
    Modularity and Design Simplicity:

    Think of the 2:00 a.m. test—if you were awakened in the
    middle of the night because of a network problem and had to figure out the
    traffic flows in your network while you were half asleep, could you do it?
    · Share on FacebookShare on Twitter
Sign In or Register to comment.