2 questions related to transport layer

Hi All
I wish u r all in a very good health.I wish u could help me with those 2 questions about transport layer.

1) For layer 4 converstion to happen, each of the source and destination must have a pair of socket contain port number and network address.

My question : Is the port number and network address contained in the socket of the source (for example) are port number and network address of source or destination ????

2) when i telnet to the router from command prompt (start --> run ---> cmd ---> telnet x.x.x.x) and then issue the command "netstat -n" , i found information about this session that it is established, but when i telnet to router through web browser and issue the command , i didn't found any information about this session

Thanks in advance

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

EdTheLad

eng_ahmedas wrote:

1) For layer 4 converstion to happen, each of the source and destination must have a pair of socket contain port number and network address.

My question : Is the port number and network address contained in the socket of the source (for example) are port number and network address of source or destination ????

The port numbers will be different, for instance if you wnt to telnet to a remote device you might have a source 192.168.1.1/24: 1025 and a destination 192.168.2.1/24: 23, as you can see you are trying to access the telnet port on the remote station so you need the well known port number of the destination i.e. 23, for the source you can use a range of available port numbers over 1024, the application your running will pick the next available port to use.Maybe you should check the available port ranges as im giving a rough guideline.
For question 2 i'll leave that for someone else!

Rearden

Dumb question, maybe. How are you telnetting in through a browser?