Duplex Mismatches

Hi Guys,

I started to receive some mismatch duplex errors in GNS3. Normally I would just turn these off however I decided to take a peek.
Can someone explain what the difference is between

duplex full & full-duplex

R1(config-if)#duplex full
R1(config-if)#full-duplex

For the life of me I cannot find anything on this and always went with duplex full.

Thanks!

Find more posts tagged with

Free for TechExams community: Cybersecurity salary guide

Compare cert salaries and plan your next career move

Button

Comments

mikeybinec

Cider wrote: »

Hi Guys,

I started to receive some mismatch duplex errors in GNS3. Normally I would just turn these off however I decided to take a peek.
Can someone explain what the difference is between

duplex full & full-duplex

R1(config-if)#duplex full
R1(config-if)#full-duplex

For the life of me I cannot find anything on this and always went with duplex full.

Thanks!

Never heard of full-duplex

RouteMyPacket

You know, google is your friend and much better than TE.

Cisco IOS Interface Command?Reference, Release?12.2 - Interface Commands (dce-terminal-timing enable - interface) [Cisco IOS Software Releases 12.2 Mainline] - Cisco

full-duplex

To specify full-duplex mode on full-duplex single-mode and multimode port adapters, use the full-duplex command in interface configuration mode. To restore the default half-duplex mode, use the no form of this command.
full-duplex
no full-duplex